Ambient Tiny Lockit - ACN TL User Manual
Page 22
20
www.ambient.de
8.
LED Indications
As used to from former devices of the Cockit Time Code family, the ACN-TL has a red and a
green flashing LED to display operation and battery status:
0 1 2 3 4 seconds:
● ● ● ● ● red
flashing in 1 second intervals: running, but not jammed or set.
● ● ● ● ● green
flashing in 1 second intervals: running, jammed or set manually.
This is the normal operation mode.
● ●● ●●
red
double flash every 2seconds: battery low, not jammed or set.
● ●● ●●
green
double flash every 2seconds: battery low, jammed or set.
● ●● ●● ●● ●●
red
double flash every second: TC / video not sync, not jammed or set.
● ●● ●● ●● ●●
green
double flash every second: TC / video not sync, jammed or set.
The double flash on every second is shown while invalid combinations are configured or
while syncing the genlock signal to time code after configuration changes or jamming.
● ●●● ● ●●●
combination of not sync and low battery, not set or jammed.
● ●●● ● ●●●
combination of not sync and low battery, set or jammed.
●
●
●
●
●
●
●
●
●
●
alternating colors during firmware update.
9.
Firmware Update
New features, improvement and fixes for the ACN-TL will be available for download from our
website:
http://www.ambient.de/en/products/ambient-recording/clockit-timecode/tiny-lockit.html
The firmware update comes as a executable file including the programming interface and
the firmware file.
Connect the ACN-TL to a computer running a Microsoft Windows® operating system using a
USB-A cable to Lemo series 0B 5-pin connector
and run the updater. Press the “UPDATE” button.
Wait until the message “update successful” appears.
The adapter cable from USB-A to Lemo 5-pin is available from Ambient recording.
Item code ACN-USB
Contact us for bug reports and suggestions through our contact form.