Ambient Tiny Lockit - ACN TL - Manual (Page 15)

13 www.ambient.de
TC MENU
Enter the TC menu to adjust the time code frame
rate, MIDI time code (MTC) functions and time
code output level for pin 5 Lemo/TC.
TC > FPS
Select TC for adjusting the frame rate. Adjust by
toggling the config switch left/right, push in to select
new frame rate:
Rates: 23.976, 24, 25, 29.97, 30, 29.97D, 30D fps (D =
drop frame)
If settings are changed, confirmation is required:
Pushing the config switch while “old” is highlighted,
discards the changes and returnsto the main menu.
Pushing the config switch while “new” is highlighted
will set the time code signal to the selected rate.
TC > MTC
Select MTC to control the Midi Time Code options:
MTCout: this is the default mode. The ACN-TL always
puts out MTC, unless the USB port is set too COM (see
SYS > Config > Lemo/ACN > USB)
The Lemo/ACN Socket switches to USB whenever a 5
Volt USB power is recognized.
MIDI>LTC: MTC received through USB will be
converted into LTC and put out on both Lemo sockets,
pin 5.
LTC>MIDI: LTC received on Lemo/TC pin 2 will be
converted and put out as MTC via USB.