Rockwell Automation FlexPak Plus DC Drive Reversing Contactor Kit Non-Regenerative User Manual
Product description
Reliance and MinPak are trademarks of Rockwell Automation.
© 1998 Rockwell International Corporation
Reversing Contactor Kit
for Non-Regenerative FlexPak Plus DC Drives
Model Number 14C293
Instruction Manual D2-3293-1
Product Description
Installation of the Reversing Contactor enables a single-phase, non-regenerative FlexPak™ Plus DC drive to
provide both forward and reverse motor control. The standard factory-shipped drive offers unidirectional motor
control only.
When the Reversing Contactor kit is installed, the drive’s M-contactor functions as the forward contactor. Motor
direction is manually selected using the forward/reverse switch on the operator’s control station (M/N 9C300).
See FlexPak Plus drive instruction manual D-3900 for information on the control station.
The Reversing Contactor is pre-assembled at the factory and includes all of the necessary jumper wires and
mounting hardware. The contents of the kit are listed in table 1.
!
ATTENTION: Only qualified electrical personnel familiar with the construction and operation of
this equipment and the hazards involved should install, adjust, operate, or service this equipment.
Read and understand this manual and other applicable manuals in their entirety before
proceeding. Failure to observe this precaution could result in severe bodily injury or loss of life.
Table 1 – Contents of the Reversing Contactor Kit
Description
Quantity
Part Number
Reversing Contactor
1
69326-30R
Mounting Screw, 8-32 x 3/8
3
601741-62C
Mounting Bracket
1
608878-90A
Mounting Screw, 8-32 x 3/4
2
601741-62F
Control Wire Harness with Connector
1
700867-63S
Wire Harness A1/A2
1
700867-67X
Jumper 45
1
608808-90TJ
Jumper 47
1
608808-90TK
Insulating Mounting Plate
1
608887-10R
Capacitor Assembly
1
608870-21S
Insulator Sheet
1
410296-37A
Instruction Manual
1
D2-3293
Trademarks not belonging to Rockwell Automation are property of their
respective companies.