Rockwell Automation CEP9-EOS-SDS Sprecher+Schuh CEP9 E300 Operator Stations User Manual
Cep9 operator stations, Installation instructions, Cat cep9-eos-scs; cep9-eos-sds)
WARNING: To prevent electrical shock, disconnect from power source before installing or servicing. Follow NFPA 70E requirements. Install in suitable enclosure. Keep free from contaminants.
Installation, adjustments, putting into service, use, assembly, disassembly, and maintenance shall be carried out by suitably trained personnel in accordance with applicable code of practice. In case of
malfunction or damage, no attempts at repair should be made. The product should be returned to the manufacturer for repair. Do not dismantle the product.
Features
Installation
Installation Instructions
CEP9 Operator Stations
(Cat CEP9-EOS-SCS; CEP9-EOS-SDS)
Start Forward / Speed 1
Start Reverse / Speed 2
Local / Remote
Stop
Reset
Start Forward / Speed 1
Start Reverse / Speed 2
Local / Remote
Stop
Up
Down
Reset
Escape
Power LED
Trip / Warn LED
Power LED
Trip / Warn LED
Enter
Select
2
1
1
2
3
1.7 N.m
(15 lb-in)
0
RESE
T
LO
CAL
REMO
TE
0
RESE
T
SELEC
T
ESC
REMO
TE
LO
CAL
0
RESE
T
SELEC
T
ESC
REMO
TE
LO
CAL
800F-AW2
Additional Resources:
Go to http://www.sprecherschuh.com/library/literature/
Click
1
2
CEP9-EOS-SCS
CEP9-EOS-SDS (Requires control module firmware v3.000 of higher)
For use on a flat surface of a Type 4X Enclosure