beautypg.com

Rockwell Automation Flex/WebPak 3000 Operator Interface Module (OIM) Kit, M/N 925WK0101 User Manual

Webpak 3000 operator interface module (oim) kit, Product description, Preparing to replace the oim

background image

©1999 Rockwell International Corporation

WebPak and Reliance are trademarks of Rockwell Automation.

WebPak 3000 Operator Interface Module (OIM) Kit

M/N 925WK0101

Instruction Manual D2-3461

Product Description

The WebPak 3000 Operator Interface Module (

OIM

) Kit is used to replace the drive’s built-in keypad and display.

The

OIM

enables you to change drive parameters, operate the drive, and monitor drive operation. The contents

of the kit are listed in table 1.

Preparing to Replace the OIM

Before replacing the

OIM

, disconnect power from the drive.

You will need the following tools:

• #1 Phillips screwdriver

• #2 Phillips screwdriver

• M7 Hex wrench or socket wrench

Accessing the OIM and Disconnecting It from the Regulator Board

Important: Unless otherwise indicated, keep all hardware for the replacement procedure.

Step 1. Loosen the screws that secure the front cover to the drive.

Step 2. Remove the front cover.

!

ATTENTION: Only qualified electrical personnel familiar with the construction and operation of
this equipment and the hazards involved should install, adjust, operate, or service this equipment.
Read and understand this manual in its entirety before proceeding. Failure to observe this
precaution could result in severe bodily injury or loss of life.

ATTENTION: Do not install or remove the

OIM

with power applied to the drive. Disconnect and

lockout incoming power before attempting installation or removal. Failure to observe this
precaution could result in severe bodily injury or loss of life.

Table 1 – Contents of the WebPak 3000 Operator Interface Module Kit

Description

Quantity

Part Number

Operator Interface Module

1

807313-2R

Instruction Manual

1

D2-3461