Rockwell Automation T3834 ICS Regent Continuous Control Package for Winterpret - Manual

ICS Regent
®
PD-6044
Industrial Control Services 1
Continuous Control Package for
W
INTERPRET
Continuous Control Function Block for PID
Control (T3834)
Issue 1, March, 06
The Continuous Control package for W INTERPRET is an
add-in software package which allows the user to create
continuous control function blocks for Regent application
programs. When installed on the PC, the continuous
control package is seamlessly integrated with the base
W
INTERPRET software.
Continuous Control is used to maintain a measured
process signal at a predetermined value and provides the
user with three different control modes: Proportional,
Integral and Derivative. These modes give Continuous
Control the term ‘PID’. Each function block allows the user
to define up to 16 control loops (also known as controllers).
Software Installation
The Continuous Control package is installed on the PC
running the W
INTERPRET application software. The
W INTERPRET base package provides the necessary
installation software to install this add-in package. The
Continuous Control package should be installed at the
same time or after you have installed the W
INTERPRET
base package.
Installation Procedure
IMPORTANT!
The files on the Continuous Control package diskette are
in compressed form. You cannot simply copy the files to
your hard drive — they must be decompressed before they
will run. You must have the W
INTERPRET base package