Rockwell Automation MPF-Bxxx Food Grade Servo Motor - Manual (Page 20)

20 MP-Series Food-grade Servo Motor with 100 mm to 165 mm Frame Size
Rockwell Automation Publication MP-IN004E-EN-P - January 2014
Motor Cables and Accessory Kits
This section describes accessories that are available for MP-Series food-grade motors.
Motor Cables
Factory manufactured feedback and power cables are available in standard cable lengths. They
provide the sealing needed to achieve environmental ratings and shield termination.
For a complete listing of available cables, contact your nearest Rockwell Automation sales office
or refer to the Kinetix Motion Accessories Specifications Technical Data, publication
GMC-TD004 .
Shaft Seal Kits
A shaft seal is a barrier that can prevent moisture and particles from entering the motor bearings.
Motors are shipped with a polytetrafluoroethylene (PTFE) shaft seal installed.
Shaft seals are subject to wear and require periodic inspection and replacement. Replacement is
recommended every 3 months, not to exceed 12 months, depending on use.
Catalog numbers for the motors and corresponding replacement shaft seal kits are listed in the
table.
For instructions on how to install a shaft seal, refer to the Shaft Seal Kit Installation Instructions,
publication
2090-IN012 .
IMPORTANT Shaft seals must be lubricated with a food-grade grease such as Total Nevastane XS80.
Lubricant is supplied with the shaft seal kits.
Third-party shaft seals are not approved for use with these motors. The use of third-party shaft seals voids any
implied or expressed warranties.
Motor Cat. No. Shaft Seal Kit Cat. No.
MPF-A310, MPF-A320, MPF-A330, MPF-B310,
MPF-B320,MPF-B330
MPF-SST-A3B3
MPF-A430, MPF-B430 MPF-SST-A4B4
MPF-A4530, MPF-A4540, MPF-B4530, MPF-B4540 MPF-SST-A45B45
MPF-A540, MPF-B540 MPF-SST-F165