Rockwell Automation 20D PowerFlex 700H/S Spare Parts User Manual
Rockwell Automation Equipment
Installation Instructions
PowerFlex
®
700S and 700H Spare Parts
Finding Specific Information
Installation information for this part can be found in the PowerFlex
Hardware Service Manual which is written for the frame size of drive being
serviced.
Consult the Rockwell Automation Literature Library web site to determine
the proper Hardware Service Manual at:
www.rockwellautomation.com/literature
!
ATTENTION: To avoid an electric shock hazard, verify that the
voltage on the bus capacitors has discharged before performing
any work on the drive. Measure the DC bus voltage at the DC+ &
DC- terminals of the Power Terminal Block. The voltage must be
zero.
!
ATTENTION: HOT surfaces can cause severe burns. Do not
touch the heatsink surface during operation of the drive. After
disconnecting power allow time for cooling.
!
ATTENTION: This drive contains ESD (Electrostatic
Discharge) sensitive parts and assemblies. Static control
precautions are required when installing, testing, servicing or
repairing this assembly. Component damage may result if ESD
control procedures are not followed. If you are not familiar with
static control procedures, reference A-B publication 8000-4.5.2,
“Guarding Against Electrostatic Damage” or any other
applicable ESD protection handbook.
!
ATTENTION: The sheet metal cover and mounting screws on
the ASIC Board located on the power structure are energized at
(-) DC bus potential high voltage. Risk of electrical shock, injury,
or death exists if someone comes in contact with the assembly.