Rockwell Automation 4100-IF2 IF2 I/O Interface to PDM Installation Instructions - Manual

Publication 4100-IN001A-EN-P- February 2001
Installation Instructions
IF2 I/O Interface to PDM
(Catalog Number 4100-IF2)
The IF2 I/O Interface to PDM is a printed circuit board intended for
use with the positioning drive modules (PDM). The purpose of this
board is to reverse the polarity of the I/O circuit to remove the
problem of compatibility that may arise from connecting any
external control conductors to the I/O.
.
See page:
Important User Information 2
Allen-Bradley Support 3
Compliance to the European Union Directive 4
Low Voltage Directive 4
Preventing Electrostatic Discharge 5
Overview 6
Installation 7
Mounting 7
Wiring 8
Wiring Cable Flying Leads to the Plugs 8
Wiring the P1 Connector 10
Wiring Diagram 10
Wiring the P2 User Connector 11
Cables 11