Rockwell Automation 6189V-35HDDST160 Hard Disk Drive - Manual (Page 4)

4 Hard Disk Drive (HDD)
Publication 6177R-IN002B-EN-P - November 2009
Before You Begin
Review the specifications of a new component before installing it to make sure it is
compatible with the computer. Record the model and serial number, and any other pertinent
information of new components for future reference.
Required Tools
These tools are required to install a hard disk drive (HDD).
• #2 Phillips screwdriver
• Antistatic wrist band
Pre-installation Procedure
Perform this pre-installation procedure before removing the side cover or accessing a
hardware component.
1. Turn off the computer and all peripherals connected to it.
2. Disconnect power from the computer to avoid exposure to high energy levels.
If necessary, label each one to expedite reassembly.
3. Disconnect telecommunication cables to avoid exposure to shock hazards from
ringing voltages.
ATTENTION
To avoid voiding your product warranty, use only Rockwell Automation
Allen-Bradley approved replacement parts and accessories.
IMPORTANT Make sure to read and understand the entire installation or removal procedure
before you begin to configure the computer hardware.
IMPORTANT When installing hardware components that require access to internal
components, first back up all computer data to avoid loss of data.