Rockwell Automation 6180 Data Storage Drives (for 6180 Industrial Computers) - Manual

Data Storage Drives
(For 6180 Industrial Computers)
This document describes how to install or remove a hard disk or
solid state drive from the 6180 Industrial Computer. Drive
specifications are also provided.
The 6180 Industrial Computer supports the following hard disk
drives.
Hard Disk Drive Catalog No.
80 MByte IDE 2.5 Inch Solid State 6189-SD80
2.0+ GByte EIDE 3.5 Inch 6189-HD20
3.0+ GByte EIDE 3.5 Inch 6189-HD30
4.0+ GByte EIDE 3.5 Inch 6189-HD40
This section gives instructions on how to install or remove a drive
from the 6180 Industrial Computer.
Internal components may be damaged by Electrostatic Discharge
(ESD). Make sure you wear a grounding strap whenever handling
circuit boards, memory modules or other internal components.
!
ATTENTION: Wear a wrist strap (well grounded)
and perform work in a static safe environment.
Electrostatic discharge can damage the 6180 Computer
and components.
Also observe the following precautions:
•
Always handle the drive by its metal frame.
•
Store a drive in an anti-static bag when it is not installed.
•
Avoid touching the cable connectors.
•
Never disconnect or connect a drive with power turned on.
* The 1.3 GByte and 1.6 Gbyte drives (Catalog No. 6189-HD13/A and 6189-HD16/A) are no
longer available. However, the instructions in this document for removal and replacement are
still applicable to these drives.
Instructions
Available Drives*
Installing / Removing
a Drive