Rockwell Automation 2100 Replacing Line Terminal Guards - Manual (Page 2)

CENTERLINE Motor Control Centers Replacing Line Terminal Guards
Publication 2100-IN008B-EN-P - March 2014 XXXXXX-XX
Supersedes Publication 2100-IN008A-EN-P - November 2000 Copyright © 2014 Rockwell Automation, Inc. All rights reserved. Printed in the U.S.A.
Rockwell Automation maintains current product environmental information on its website at
Allen-Bradley, Rockwell Software, Rockwell Automation, and CENTERLINE are trademarks of Rockwell Automation, Inc.
Trademarks not belonging to Rockwell Automation are property of their respective companies.
Rockwell Otomasyon Ticaret A.Ş., Kar Plaza İş Merkezi E Blok Kat:6 34752 İçerenköy, İstanbul, Tel: +90 (216) 5698400
Application This instruction sheet is to be used for replacing the line terminal guards used in
Bulletin 2100 and 2400 fusible disconnect units.
Instructions The line terminal guards are held in place by a rubber handle that fits into two
holes in the disconnect.
1. To remove, pull rubber handle forward.
Discard old line terminal guard.
2. Grasp new line terminal guard by the rubber handle and firmly push two
round ends into corresponding holes in disconnect until guard is firmly in
place.
ATTENTION: De-energize all power sources before attempting to replace the
line terminal guard. Failure to de-energize all power sources can result in severe
injury or death.