Rockwell Automation 2711-NR8K MicroView to PanelView 300 Micro Adapter Plate - Manual (Page 3)

Publication 2711-IN051A-EN-P - September 2005
MicroView (Bulletin 2707) to PanelView 300 Micro (Bulletin 2711) Adapter Plate 3
Install the Adapter Plate The following steps provide instructions for installing the adapter
plate in an existing MicroView panel opening.
1. Cut and drill the appropriate mounting holes in the enclosure or
panel.
2. Remove two mounting nuts from the hardware bag provided
with the product (six mounting nuts provided).
3. Position the adapter plate in the panel or enclosure mounting
hole.
4. Install nuts and alternately tighten the nuts to a torque of
1.13 Nm (10 in-lb).
Mount the PanelView 300
Micro The following instructions provide panel cutout dimensions for the
PanelView 300 Micro in an existing enclosure for the MicroView.
The PanelView 300 Micro mounts in the adapter cutout. When it is
properly installed, the faceplate provides a NEMA Type 4 rating. To
install the PanelView 300 Micro:
1. Remove the six mounting nuts from the hardware bag provided
with the product.
2. Position the PanelView 300 Micro in the adapter plate.
3. Install nuts and alternately tighten the nuts to a torque of
1.13 Nm (10 in-lb).
Additional Resources For more information regarding the PanelView 300 Micro:
TIP
The adapter plate and unit have mounting
gaskets. You need to press them against the
enclosure before installing the nuts.
Publication Name Publication Number
PanelView 300 MicroView Terminals
Installation Instructions 2711-IN008
Standard PanelView Operator Terminal User
Manual 2711-UM014