Rockwell Automation 6189V-CFSSD16GB Memory Module (DRAM) for 6181X Industrial Computers - Manual (Page 2)

Allen-Bradley, Rockwell Software, and Rockwell Automation are trademarks of Rockwell Automation, Inc.
Trademarks not belonging to Rockwell Automation are property of their respective companies.
Rockwell Otomasyon Ticaret A.Ş., Kar Plaza İş Merkezi E Blok Kat:6 34752 İçerenköy, İstanbul, Tel: +90 (216) 5698400
Publication 6189V-IN004A-EN-P - September 2010
Copyright © 2010 Rockwell Automation, Inc. All rights reserved. Printed in China..
Upgrade the System Memory
Follow these steps to upgrade the system memory.
1. Disconnect power from the computer.
2. Remove the rear cover.
3. If you want to install an additional module instead of replacing the
default one, proceed to
step 8 .
4. Clip the cable tie of the existing memory module (1) and remove it from
the memory slot (2).
5. Completely open the retaining latches securing the memory module (3).
This forces the module up in the slot and makes it easier to remove.
6. Gently remove the memory module from its slot (4).
7. Place the memory module on a static-dissipating work surface or inside
an antistatic bag.
8. Hold the new memory module by its edge and remove it from its
protective packaging.
9. Orient the module so that the notch on its bottom edge aligns with the
keyed surface of the DIMM slot (5).
10. Push the module at both ends to seat it fully into the slot (6).
The holding clips will automatically lock into place once the module has
been seated.
11. Fasten a replacement cable tie around the DIMM slot latches (7).
12. Pull the end of the cable tie to lock it in place (8).
13. Cut the excess length of the cable tie.
14. Reinstall the rear cover.
15. Apply power to the computer.
IMPORTANT Reinstalling the cable tie is required to meet hazardous locations,
mechanical shock, and vibration requirements.
6181X-12TPXPDC
display computer
3
3
4
5
6
6
7
8
8