Rockwell Automation 1798-IE4 FlexArmor Analog Input Module - Manual (Page 4)

4 FlexArmor Analog Input Module
Publication 1798-IN007A-EN-P - April 2002
Related Publications
•
For DeviceNet software configuration information, refer to the
1798-ADN User Manual, publication 1798-UM001.
•
For PROFIBUS configuration information, refer to the
1798-APB User Manual, publication 1798-UM002.
Install the Module into the Baseplate
For instructions on how to mount the FlexArmor Baseplate, refer to
publication no. 1798-IN003.
To install the module into the FlexArmor Baseplate:
1. Hold the module at an angle and engage the top of the
module in the indention on the rear of the Baseplate.
2. Press the module down flush with the panel until the locking
lever locks.
3. Repeat these steps for each I/O module and each remaining
Baseplate I/O slot.
ATTENTION
!
Preventing Electrostatic Discharge
This equipment is sensitive to electrostatic
discharge, which can cause internal damage and
affect normal operation. Follow these guidelines
when you handle this equipment:
•
Touch a grounded object to discharge
potential static.
•
Wear an approved grounding wriststrap.
•
Do not touch connectors or pins on
component boards.
•
Do not touch circuit components inside the
equipment.
•
If available, use a static-safe workstation.
•
When not in use, store the equipment in
appropriate static-safe packaging.
IMPORTANT
I/O modules can be installed in any slot location
to the right of the adapter module. The adapter is
capable of addressing up to eight I/O modules.