Rockwell Automation 1797-TCAP ControlNet Ex Tap Dummy Load Installation - Manual (Page 6)

6 ControlNet Ex Tap Terminator Installation Instructions
1797-5.30 - September 1999
Installation in Zone 1
Make certain that you only connect ControlNet Ex products to other
intrinsically safe system products to maintain the integrity of the
intrinsically-safe system.
Electrostatic Charge
Protect the system against electrostatic charge. Post a sign near the adapter:
Attention! Avoid electrostatic charge. For your convenience, a sign
which can be cut out is included in this installation instruction.
European Community Directive Compliance
If this product has the CE mark it is approved for installation within the
European Community or EEA regions. It has been designed and tested to
meet the following directives.
EMC Directive
This product is tested to meet the Council Directive 89/336/EC
Electromagnetic Compatibility (EMC) by applying the following
standards, in whole or in part, documented in a technical construction file:
• EN50081-2
EMC - Generic Emission Standard, Part 2 - Industrial Environment
•
EN50082-2
EMC - Generic Immunity Standard, Part 2 - Industrial Environment
!
ATTENTION: This tap terminator cannot be used in an
intrinsically safe environment after it has been exposed to
non-intrinsically safe signals.
41307