Rockwell Automation 2711P-RPPU PanelViewPlus Logic Module Pullup Board - Manual (Page 4)

Publication 2711P-IN028A-EN-P - December 2005 PN 41061-372-01(1)
Supersedes Publication XXXX-X.X.X - Month Year Copyright © 2005 Rockwell Automation, Inc. All rights reserved. Printed in the U.S.A.
1. Disconnect power from the terminal.
2. If the Display Module is removed from the panel, set the terminal, display
side down, on a clean, flat, stable surface.
3. Remove the label covering the Communication Module connector on the
Logic Module.
4. Position the Pullup Board over the Logic Module so that the connector on
bottom of the board aligns with connector on Logic Module.
5. Press the Pullup Board firmly into place.
Allen-Bradley, PanelView Plus, VersaView and Rockwell Automation are trademarks of Rockwell Automation, Inc.
Trademarks not belonging to Rockwell Automation are the property of their respective holders.
ATTENTION Work in a static free environment and wear a properly grounded
ESD wristband. Do not touch the Communication Module
connector or its internal circuitry to avoid ESD (Electrostatic
Discharge).
Logic Module
Pullup Board