Rockwell Automation 2711 PanelView 300 Keypad Terminal Installation Instructions - Manual (Page 5)

PanelView 300 Keypad Terminals 5
Publication 2711-IN027C-EN-P - February 2009
Enclosures
Mount the PanelView 300 keypad terminal in a panel or enclosure to protect the
internal circuitry. The terminal meets NEMA Type 12/13 and 4X (indoor use) ratings
only when properly mounted in a panel or enclosure with the equivalent rating.
Allow enough space within the enclosure for adequate ventilation. Consider heat
produced by other devices in the enclosure. The ambient temperature around the
PV300 terminal must be between 0…55
°
C (32…131
°
F).
Make provisions for accessing the back panel of the terminal for wiring,
maintenance, installing a memory card, and troubleshooting.
Required Tools
Other than the tools required to make the panel cutout, the tools required for
installation are:
•
7mm (M4) deep well socket wrench or nut driver.
•
small slotted screwdriver.
•
torque wrench (N•m, lb•in).
Mounting Dimensions
140 mm
(5.53 in.)
197 mm
(7.76 in.)
Top View
82 mm
(3.21 in.) 69 mm
(2.73 in.)