Rockwell Automation 2711-NC17 Remote RS-232 Port Assembly - Manual (Page 11)

Publication 2711-IN032C-EN-P
Remote RS-232 Port Assembly 3
Tools Required
•
No. 2 Phillips Screwdriver
•
Drill
•
Jig saw
•
Torque wrench adjustable to 1.36 N•m (12 in-lb)
Installing the Remote
RS-232 Port Assembly 1. Make a cutout in the panel door and drill four mounting holes.
Remove any burrs on the holes.
2. From the rear of the panel, install the remote serial port
assembly in the cutout.
3. Use the washers provided between the screw heads and the
front of the panel. Orient the narrow end of the washer towards
the head of the screw as shown on page 1.
4. Fasten the housing to the panel with the four mounting screws
provided. Thread one of the screws through the chain for the
protective cap. The chain should be attached to the lower left
corner. Tighten screws to 1.02-1.36 N•m (9-12 in-lb).
66.7 mm
2.625 in.
66.7 mm
2.625 in.
4.76 mm
3/16 in.
4 Places
dia. 76.2 mm
+ 0.05 -0.00
dia. 3.00 in.
+ 0.025 -0.000