Rockwell Automation 1771-OND INSTL.INSTR AC (24V) OUTPT.MOD - Manual

Publication 1771Ć5.41 - May 1996
AC (24V) Output Module
Cat. No. 1771-OND Series B
This document provides information on:
•
important pre-installation considerations
•
power supply requirements
•
installing the module
•
setting the fault mode
•
using the indicators for troubleshooting
•
replacing the fuses
•
module specifications
This module must be used with a 1771-A1B thru -A4B or later I/O
chassis. If you are using a 1771-ASB remote I/O adapter you may
use any combination of I/O modules. Otherwise, make sure no other
output module or single card block transfer module is placed in the
same I/O group.
If this product has the CE mark it is approved for installation within
the European Union and EEA regions. It has been designed and
tested to meet the following directives.
EMC Directive
This product is tested to meet Council Directive 89/336/EEC
Electromagnetic Compatibility (EMC) and the following standards,
in whole or in part, documented in a technical construction file:
•
EN 50081-2EMC – Generic Emission Standard, Part 2 –
Industrial Environment
•
EN 50082-2EMC – Generic Immunity Standard, Part 2 –
Industrial Environment
This product is intended for use in an industrial environment.
Installation Instructions
To The Installer
PreĆinstallation
Considerations
European Union Directive
Compliance