Rockwell Automation 1734-EP24DC Point I/O Expansion Power Supply Installation Instructions - Manual (Page 11)

POINT I/O 24V dc Expansion Power Supply 11
Publication 1734-IN058B-EN-P - June 2005
1. Remove the module to the right of the power supply from its
base unit.
2. Position the power supply vertically above the DIN rail.
3. Slide the power supply down allowing the interlocking side
pieces to engage the adjacent modules (both left and right
sides).
4. Press firmly to seat the power supply on the DIN rail.
The power supply locking mechanism snaps into place.
5. Reinsert the module into the base next to the expansion
power supply.
Wire the Power Supply
WARNING
If you connect or disconnect wiring while the field-side
power is on, an electrical arc can occur. This could cause
an explosion in hazardous location installations. Be sure
that power is removed or the area is nonhazardous before
proceeding.
ATTENTION
Use the 1734-EP24DC expansion power supply only with
adapter class products.
ATTENTION
Use the 1734-EP24DC expansion power supply only with
1734 POINT I/O adapters, such as the 1734-ADN
DeviceNet adapter.