Rockwell Automation 1753-CFBBASIC Certified Function Blocks for RSLogix Guard PLUS! User Manual
Certified function blocks for rslogix guard plus, Installation instructions, Catalog number 1753-cfbbasic) system requirements
Publication 1753-IN008C-EN-P - September 2005
Installation Instructions
Certified Function Blocks for RSLogix Guard
PLUS!
(Catalog Number 1753-CFBBASIC)
System Requirements
Make sure your personal computer meets the following system requirements:
Install the Rockwell Automation Certified Function Block
Library
1. Install RSLogixGuard PLUS! Software on your computer if you have not
already done so.
Make sure that your version of RSLogixGuard PLUS! Software is compatible.
See the System Requirements.
2. Insert the RA Certified Function Block Library CD in your CD drive. If the
installation does not start automatically, run Setup.exe manually from the
installation CD.
3. Follow the on-screen prompts to complete the installation.
Category
Requirement
Personal Computer
Pentium
®
II, 500 MHz
Operating System
Windows NT/2000/XP
RSLogix Guard PLUS! v 3.5 or
Project Management version 3.5 (Build 6817)
Hardware Management version 4.0.26
RSLogix Guard PLUS! v 4.0 or
Project Management version 4.0 (Build 6104)
Hardware Management version 6.56.0
RSLogix Guard PLUS! v 4.1
Project Management version 4.1 (Build 6111)
Hardware Management version 7.56.4
Free Hard Disk Space
at least 10 MB space for certified function block library