Rockwell Automation 1771-IR INSTL.INSTR RTD INPUT MODULE - Manual

Publication 1771-5.50 – October 1996
RTD Input Module
(Catalog Number 1771-IR Series C)
Use this document as a guide when installing the 1771-IR/C
input module.
To See page
Prevent Electrostatic Discharge Below
Understand Compliance to European Union Directives 1
Understand Product Compatibility 2
Calculate Power Requirements 2
Determine Module Placement 3
Key the Backplane Connector 3
Install the Module and Field Wiring Arm 4
Connect Wiring to the Field Wiring Arm 5
Ground the Chassis and Module 6
Configure the Module 7
For this reference information See page
Status Indicators 9
Troubleshooting 9
Specifications 11
Differences Between Series 12
The RTD input module is sensitive to electrostatic discharge.
!
ATTENTION: Electrostatic discharge can damage
integrated circuits or semiconductors if you touch
backplane connector pins. Follow these guidelines
when you handle the module:
•
Touch a grounded object to discharge static potential
•
Wear an approved wrist-strap grounding device
•
Do not touch the backplane connector or
connector pins
•
Do not touch circuit components inside the module
•
If available, use a static-safe work station
•
When not in use, keep the module in its
static-shield bag
This product has the CE mark and is approved for installation within
the European Union and EEA regions. It has been designed and
tested to meet the following directives.
This icon is used when
additional information is
available in the RTD Input
Module User Manual,
publication 1771-6.5.76.
If you need a copy of this
manual, fax the enclosed User
Manual Request Card to
1-800-576-6340. If you are
outside the U.S., fax the card to
1-330-723-4036.
Installation Instructions
Contents
Prevent Electrostatic
Discharge
Understand Compliance to
European Union Directives