Connect the output cord sets to the maxum module – Rockwell Automation 1792D-OB4D ArmorBlock MaXum 8 Output Module Series B User Manual

Page 6

6 ArmorBlock MaXum 8 Output Module Series B

Publication 1792D-IN003B-EN-P - September 2000

Connect the Output Cord Sets to the MaXum Module

This module uses 5 pin micro (12mm) style PCB mounted connectors.

Eight micro caps cover the connectors on your module. Remove the
caps and connect your cables to the appropriate ports.

Use the micro caps to cover and seal unused ports. A pinout diagram
for the connectors is shown below.

Please refer to publication 889-5.0 for Rockwell Automation cables
and cord sets offerings.

ATTENTION

ATTENTION:

• Make sure all connectors and caps are

securely tightened to properly seal the
connections against leaks and maintain
IP67 requirements.

• For maximum noise immunity, input and

output cable return wires must be
properly terminated. When inputs and
outputs are connected in loopback, return
wires should be connected together.

• I/O cable length should be less than 30

meters.

41452

Output Micro-Connector

(View into Sockets)

Pin 1 Not Used
Pin 2 Not Used
Pin 3 Auxiliary Power Ground
Pin 4 Output A
Pin 5 Not Used