Rockwell Automation 1791D-N4CV2X CompactBlock I/O for DeviceNet Expansion Module I.I. - Manual (Page 11)

CompactBlock I/O Analog Combination Input/Output Expansion Module 11
Publication 1791D-IN002A-EN-P - June 2003
Insert the Terminal Block
To insert the CompactBlock terminal block.
1. Insert the terminal block by aligning it and pushing it back until it
rests against the back of the module.
2. Tighten the screws on each side of the terminal block until the
terminal block is firmly in place.
Word/Bit Definitions
The following table lists the combination of input and output modules and
the input and output bytes produced and consumed with the analog
expansion module
.
IMPORTANT
When installing an expansion module, refer to the table
below to see how many bytes are produced and
consumed by the modules.
DeviceNet
Network PROFIBUS
Network Remote I/O
Network
Base I/O Points Prod.
(input
bytes)
Cons.
(output
bytes) Prod.
(input
bytes)
Cons.
(output
bytes) Prod.
(input
bytes)
Cons.
(output
bytes)
16
input 16 input
digital
4 in/ 2 out
analog 14 4 12 4 12 12
16
output 16 output
digital
4 in / 2 out
analog
12 6 10 6 12 12
8 in /
8 out
8 in/ 8 out
4 in / 2 out
analog 12 6 12 6 12 12
4 in /
4 out
4 in/ 4 out
4 in / 2 out
analog 12 6 12 6 12 12