Rockwell Automation 1771-IXE Thermo/MV Input Installation Instructions - Manual

Publication 1771Ć5.49 - October 1996
Thermocouple/Millivolt
Input Module
Cat. No. 1771-IXE Series C
Use this document as a guide when installing the 1771-IXE series C
thermocouple/mV input module.
To See page
Prevent Electrostatic Discharge Below
Understand Compliance to European Union Directives 2
Understand Product Compatibility
2
Calculate Power Requirements 3
Determine Module Placement 3
Key the Backplane Connector 3
Install the Module and Field Wiring Arm 4
Connect Wiring to the Field Wiring Arm 5
Ground the Chassis and Module 6
Configure the Module 7
For this reference information See page
Default Configuration 9
Status Indicators 9
Troubleshooting 9
Specifications 11
The thermocouple/mV input module is sensitive to electrostatic
discharge.
!
ATTENTION: Electrostatic discharge can damage
integrated circuits or semiconductors if you touch
backplane connector pins. Follow these guidelines
when you handle the module:
•
Touch a grounded object to discharge static potential
•
Wear an approved wrist-strap grounding device
•
Do not touch the backplane connector or
connector pins
•
Do not touch circuit components inside the module
•
If available, use a static-safe work station
•
When not in use, keep the module in its
static-shield bag
This icon is used when additional
information is available in the
Thermocouple/mV Input Module User
Manual, publication 1771Ć6.5.77.
If you need a copy of this manual, fax the
enclosed User Manual Request Card to
1.800.576.6340. Outside the USA, fax the
card to 1.330.723.4036.
Installation Instructions
Contents
Prevent Electrostatic
Discharge