Rockwell Automation 1784-PMCSY4 Synchronization Cable Installation Instructions - Manual

1 Publication 1784-IN008A-EN-P - November 2000
Installation Instructions
Synchronization Cable
(Catalog Number 1784-PMCSY4)
Up to four (4) 1784-PM02AE cards may be installed in a single
computer provided there are enough PCI Bus slots available. A sync
cable is required to keep the cards synchronized. This is a ribbon
cable with four connectors that fit to the cards.
The cable is a 28AWG, 7/36 stranded, ribbon cable with centerline
spacing of .05mm. The connectors are 10 way ribbon cable receptacles
of gold over nickel.
Figure 1 1784-PMCSY4 Cable
The 10 pin connector attaches to the card at the opposite edge from
the PCI Bus connection.
IMPORTANT
The connectors should be fitted the same on all
cards, as the mating connector is not polarized.
60 mm 60 mm 60 mm
10 pin ribbon connectors