Rockwell Automation 1771-IBD INSTL INSTR DC (10-30V) INPUT - Manual

Publication 1771-5.53 – April 1999
DC (10Ć30V) Input Module
Cat. No. 1771-IBD Series B
Use this document as a guide when installing the catalog number
1771-IBD series B input module.
To See page
Prevent Electrostatic Discharge Below
Important Preinstallation Considerations 2
Understand Compliance to European Union Directives 2
Calculate Power Requirements 3
Set the Filter Off Delay 3
Key the Backplane Connector 3
Install the Module and Field Wiring Arm 4
Connect Wiring to the Field Wiring Arm 5
For this reference information See page
Status Indicators 6
Troubleshooting 6
CSA Hazardous Location 7
Specifications 8
This input module is sensitive to electrostatic discharge. This module
is shipped in static-shielded packaging to guard against electrostatic
discharge damage. Observe the following precautions when handling
this module.
Electrostatic Discharge Damage
!
ATTENTION: Electrostatic discharge can damage
integrated circuits or semiconductors if you touch
backplane connector pins. Follow these guidelines
when you handle the module:
•
Touch a grounded object to discharge static potential
•
Wear an approved wrist-strap grounding device
•
Do not touch the backplane connector or
connector pins
•
Do not touch circuit components inside the module
•
If available, use a static-safe work station
•
When not in use, keep the module in its original
static-shielded packaging
Installation Instructions
Contents
Prevent Electrostatic
Discharge