Rockwell Automation 1787-DNPS DeviceNet Power Supply Installation Instructions - Manual (Page 2)

1787-5.8 - February 1999
2 DeviceNet Power Supply
For specific information on the power supply requirements, see the
appropriate sections in this manual as well as the following
Allen-Bradley publications:
•
Industrial Automation Wiring and Ground Guidelines, publication
1770-4.1
•
Automation Systems Catalog, publication B111
This equipment is classified as open equipment and must be installed
(mounted) in an enclosure during operation as a means of providing safety
protection.
Installing Your Power Supply You can install your power supply on a vertical wall mount or a shelf by
using the integral mounting brackets. For more information about where to
mount your power supply, refer to the DeviceNet Cable System Planning
and Installation Manual, publication DN-6.7.2.
1. Place the power supply where you would like to mount it (either on a
shelf or vertically on a wall).
2. Attach the power supply to the selected mounting position by attaching
screws through the appropriate mounting flange.
ATTENTION: Be certain that the power supply is
protected from liquids and condensation that might occur
through ventilation. Liquids or condensation could cause
damage to the product.
IEC 3-pin connector
LED power indicator
voltage selection switch
main power switch
DeviceNet 5-pin open style connector
vertical mounting
horizontal mounting