Rockwell Automation 1326AB, 845H Encoder Feedback Adapter Kit - Manual

ALLEN-BRAD-
LEY
Instructions
1326AB Encoder Feedback
Mounting Adapter Kit
(Cat. No. 1326AB-MOD-Mxx)
Introduction This publication will guide you through installation of the 1326AB
Encoder Mounting Adapter to a 1326AB Servomotor.
Using the information below, verify that you have received the correct kit
for the motor being used.
Adapter Kit No. Use to couple an 845H Encoder to . . .
1326AB-MOD-M40 * 1326AB-B4xxx-21, -A4xxx-21 and -Axx-xx Series Motor
1326AB-MOD-M50 * 1326AB-B5xxx-21, -A5xxx-21 and -Bxx-xx Series Motor
1326AB-MOD-M60 * 1326AB-B7xxx-21, -A7xxx-21 and -Cxx-xx Series Motor
* 1326-MOD-Mxx replaces the 1326AB-MOD-Mxx-C1 and 1326AB-MOD-Mxx-C3, however will
accept the 845H encoder only.
The components contained in each kit include:
(1) Encoder Mounting Adapter w/Servo Clamps
(1) Flexible Coupling
(1) Allen Wrench, Coupling
(3) Mounting Screws, Adapter
The following items may be required for installation.
0.375-18 Pip Head Driver
Standard Screwdriver
#10-32 Hex Head Driver
Run-Out Indicator
Installation Important: This adapter is designed to accept Allen-Bradley 845H
encoders Only.
WARNING: If the motor is currently wired into a system,
assure that all power to the motor has been removed before
installing the adapter to avoid a shock hazard.
!