Rockwell Automation 1441-DYN25-MBMP Bump Test Extension Module for the Dynamix 2500 - Manual (Page 17)

Rockwell Automation Publication 1441-UM002A-EN-P - May 2011 17
Bump Test Extension Module Chapter 2
See Bump Test Parameter Descriptions on page 17 for complete
descriptions of the parameters.
5. Configure the Bump Test setup parameters.
Table 2 - Bump Test Parameter Descriptions
Parameter Description Value
Num. Channels Number of Channels you are using
in the Bump Test. 1 (X)
2 (X and Y)
3 (X, Y, and Z)
4 (X, Y, Z, R)
Sensor Type Specifies the type of sensor used
(typically Accel G). Note that the
specified sensor type determines
available options and engineering
units for subsequent setup fields. Accel (G) (default)
Accel m/s
2
Vel IPS
Vel mm/s
Disp um
Disp mil
Volts AC
Volts DC
Sensor Sensitivity Enter transducer sensitivity in
millivolts (mV) per Engineering
Unit (EU) (typically 100 mV/g). mV/EU
Range (EU) (Full Scale) Define the spectrum’s maximum
full-scale amplitude value. 1 (default), 2, 5, 10, 20, 50, 100,
200, 500, 1000
Typically 20 G for Accel
X-axis units Specify frequency units for graphic
displays. Hz (default)
CPM
Filter Displays high-pass filter settings. 2 Hz (default)
Off, 0.36 Hz, 1.1 Hz, 2Hx, 10 Hz,
70 Hz
Freq Range (Fmax) The FFT upper full-scale
frequency, up to 40,000 Hz
(2,400,000 CPM). 1000 Hz (default)