Rockwell Automation 1609 Industrial Uninterruptible Power Supply - Series B User Manual

Page 2

Bulletin 1609 Industrial Uninterruptible Power Supply

1. To access the battery compartment

remove the three screws and the

battery door.

3. Fold the battery container and seal it with tape.

4. To connect the batteries to the UPS, insert the batteries into the battery compartment, open the white

connector retainer and connect the two cables together as shown in the photo below.

2. Remove the battery container, jumper and wire harness

from the battery compartment. Place the battery

container and batteries onto a ﬂat surface. Use the

provided jumper wire to connect the batteries in series.

Connect the positive terminal (red) of the battery to the

negative terminal (black) of another battery. Connect

the red wire of the harness to the positive terminal (top

red) and the black wire of the harness to the negative

terminal (bottom black). See photo below for details.

Batteries Wiring and Installation Instruction for the UPS

Only use battery wires that have been provided with the UPS.

Warning: Do not service the 1609-SPD without disconnecting the power sources due to electric shock harzard for risk of
severe injury or death.

Publication 1609-IN013B-EN-P - August 2012 DIR 10000234490 (Version 01)

Black

Notch

End

Red