Rockwell Automation 1426-COMM-DNT PowerMonitor 5000 Unit Optional Communication Modules - Manual

Installation Instructions
PowerMonitor 5000 USB Driver Installation and
Configuration
Catalog Number 1426
The USB Device port can be used to set-up a temporary, point-to-point
connection between a personal computer and the PowerMonitor™ 5000 unit.
This connection is used for configuration, data monitoring, diagnostics, and
maintenance by using the unit's built-in web pages. The USB Device port is a
standard USB Mini-B receptacle. You need to install drivers to enable USB
communication.
To connect your personal computer to the PowerMonitor 5000 unit, use a
standard USB cable with a Type-A and Mini-B male plugs.
Topic Page
Install Drivers 3
Configure the Connection 5
Browse the PowerMonitor 5000 Web Page by Using the USB Connection 7
Additional Resources 8