Barco R9010111 - Manual (Page 28)

7. Maintenance of the D-Cine Premiere DP100
A A B C
C
Image 7-2
Lamp casing removal
7.1.2 Installation of the Lamp Unit
7.1.2.1 Installation of the lamp unit in the projector head
How to install the lamp unit
1. Place the lamp unit on the lamp base in the projector, lining up the lamp unit foot with the slots on the base. (image 7-3)
2. Push the lamp unit foot fully into the slots. (image 7-4)
3. Secure the position of the lamp unit by tightening the spring screws (A).
4. Proceed to reset the lamp parameters, see D-Cine Communicator manual.
5. To ensure maximum light output, proceed to the Xenon Bulb lamp X-Y-Z alignment (see chapter “Alignment of the Xenon bulb
lamp” in the installation manual).
Image 7-3
Moving the lamp unit foot into the base
24 R5976907 D-CINE PREMIERE DP100 02/11/2005