Switching off the d-cine premiere dp100, 1 stop image projection, 2 powering off the projector – Barco R9010111 User Manual
Page 25: Stop image projection, Powering off the projector
6. Switching Off the D-Cine Premiere DP100
6. SWITCHING OFF THE D-CINE PREMIERE DP100
Procedure for switching off the projector
•
Close the dowser.
•
Switch off the lamp
•
Switch off the projector
6.1 Stop Image Projection
How to stop image projection
1. Press the dowser button (B). (image 6-1)
The dowser shuts, indicated by the built-in Red LED ON (B1).
2. Press the lamp ignition button (A) (image 6-1).
The lamp turns off, indicated by the built-in Red LED ON (A1).
A
A
2
A
1
B
2
B
1
B
D
Image 6-1
Bulb and Dowser switching off
6.2 Powering off the projector
C
AUTION
:
To ensure maximum bulb life, first allow the lamphouse blower and the exhaust system run for at
least ten minutes after extinguishing the bulb, and then power off the projector.
How to power off the projector
1. Press the tumbler switch (A) in the “O” position (OFF state) (image 6-2)
All parts of the projector have been powered off.
2. If the projector will not be used for a long period, pull out the power connector from wall outlet.
R5976907 D-CINE PREMIERE DP100 02/11/2005
21