Rockwell Automation 1485A KwikLink Lite, Manual Crimp Tool - Manual

1
Installation Instructions
Bulletin 1485A KwikLinkt Lite, Manual crimp tool
IMPORTANT: SAVE THESE INSTRUCTIONS FOR FUTURE USE.
Refer to the product catalog pages for additional information.
Safety Precautions
S The product does not provide a safety cover or any other
safety devices. Use the product with sufficient care so that
you do not pinch your fingers in the crimp section or
between the handles.
S Do not disassemble or modify the product.
S Do not use the product for any purpose other than its
intended purpose or applications specified in the user
manuals.
S Do not drop the product or subject it to abnormal vibration
or shock. These may result in malfunction.
S The product is a manual tool. Do not attach it to any
machine or device that is not manually operated. Doing so
may result in malfunction or damage.
S Use the product with care and be careful not to drop it on
your foot.
Precautions for Correct Use
S
Do not install the crimp tool in the following locations.
S
Locations subject to corrosive gas or inflammable gas
S Locations subject to excessive dust and dirt
S Locations subject to oils, acids, or other chemicals
S Locations directly subject to vibration or shock
S The crimp tool is set to a suitable bottom dead point
(crimping height) before shipping from the factory.
Discontinue use of the crimp tool immediately if it becomes
loose or otherwise misaligned.
S
After using the crimp tool, wipe off any dirt or foreign matter
and store it in a dry location.
S Never use paint thinner or other organic solvents to clean
the crimp tool. These may damage the crimp tool.
Simple Manual Crimp Tool
Part Names
1485A--KCrimp
Crimp block
Base block
Lever
Spring
Handle
Crimp Operation
1. Set the center of the connector cover (see arrows) in the
center of the crimp block of the Crimp Tool.
1485P--K1TG4 1485P--K1DL4
2. Crimp the connector until you hear the connector lock into
place.
Note:
S
Do not crimp the edge of the connector cover.
S Do not crimp at the back of the crimp block.
S Be sure to set the Connector in the correct orientation.
Preliminary
Subject
to Change
September
3, 2008