Rockwell Automation 1492-CM1771-LD0010F Fused Field Conversion Module - Manual (Page 4)

V. Fuse Installation and Replacement
The 1492-CM1771-LD010F conversion module has sixteen (16) mechanical fuse holders with fuses located on the
circuit board inside the modules plastic case. The following explains how to replace the fuses.
1) Remove the 4 screws that hold both halves of the conversion module case together (refer to the following
Figure A).
2) Disassemble both case halves so you can access the module’s circuit board. Remove and replace the fuse or
fuses (refer to the below Figure B).
3) Reassemble the two case halves to the circuit board and replace the four screws that hold the case together
Do NOT over torque the screws (Maximum torque is 5.0 in-lbs.)
NOTES:
1) For module operation a fuse must be inserted into the fuse holder
2) Physical Fuse Size: 2AG
3) Possible Fuse Supplier: LittelFuse (Part Number: 22901.5P)
4) Maximum Fuse Current rating based on Conversion System Components: 1.5 Amps
Sixteen Fuse Holders and Fuses
(4)
PN-114282
DIR 10000060093 (Version 01)
Publication 1492-IN040B-EN-E
FIGURE B
FIGURE A