Rockwell Automation 190 Universal Instruction Sheet for Open Type Starters - Manual

22.462.960-02 Edition 01
Page 1/2
Starter Installation and Commissioning
Instructions
Important Rules
!
Read the assembly instructions before you start to install
the starter.
All installation, commissioning and maintenance work must be
carried out by qualified personnel and in accordance with
local regulations.
Before commencing installation or maintenance disconnect
from the power supply to prevent electrical shock.
Check that the technical data on the devices and in the
catalogue meet your application requirements.
The devices must be installed in a suitable enclosure having a
Protection Class that corresponds to the operating conditions
and affords adequate protection against ingress of solid
foreign bodies and water.
Before putting into service, test the operation of the control
system or assembly together with the starter according to the
applicable regulations (e.g. IEC/EN 60439, IEC/EN 60204).
Test
Installing, wiring and testing starters
1) Preparation
- Read these instructions and their appendices carefully and observe the
technical information given in the catalogue and the documentation.
- Check that the starter conforms to the required specification.
2) Installation
Mount the starter according to the chosen method of fixing and strictly observe
the rated data of the components with respect to:
- operating position
- ambient conditions such as temperature, altitude etc.
- exposure to shock and vibration
- pollution degree