Rockwell Automation 599-PL00x Accessory Kit - Manual

ATTENTION: To prevent electrical shock, disconnect from power source before installing or servicing. Install
in suitable enclosure. Keep free from contaminants.
ATTENTION: Wire leads must approach from the side, as shown, to ensure adequate electrical clearance to
mounting hardware.
Accessory Kit Installation Instructions
(Cat 599-PB00, -PL00_, -SS00)
Push Button / Selector Switch Kit
To
Terminal "3"
on Starter
To Terminal "3"
on Starter
(For 3-Position
Selector Switch)
To Terminal "3"
on Starter
(For 2-Position
Selector Switch)
To Terminal "L1"
on Starter
20 lb-in
12 lb-in
To Terminal "2"
on Starter
Spacer - Deep Cover
( 3 - Phase Only)
To
Terminal "L1"
on Starter
Spacer - Shallow Cover
( 3 - Phase Only)
Single - Phase
A
A B
B
B
A
A Single - Phase
3 - Phase
3 - Phase
B
B
B
A
A
A
1 2
BULLETIN 599 ACCESSORY KIT
INSTALLATION INSTRUCTIONS
1 1014874
G. Ushakow
M. A. Jutz
C. Sauers
7-29-05
7-29-05
7-29-05
42052-127
E - DOC
OF
N/A
N/A
N/A
REVISION
AUTHORIZATION
DR.
CHKD.
APPD.
DATE
DATE
DATE
LOCATION: MILWAUKEE, WISCONSIN U.S.A.
B-vertical.ai
DWG.
SIZE
SHEET
B
1 2 3 4 5 6 7 8
A
B
C
D
E
F
G
H
REFERENCE
DIMENSIONS APPLY BEFORE
SURFACE TREATMENT
(DIMENSIONS IN INCHES)
TOLERANCES UNLESS
OTHERWISE SPECIFIED
.XX:
.XXX:
ANGLES:
42052
THIS DRAWING IS THE PROPERTY OF
ROCKWELL AUTOMATION, INC.
OR ITS SUBSIDIARIES AND MAY NOT BE COPIED,
USED OR DISCLOSED FOR ANY PURPOSE
EXCEPT AS AUTHORIZED IN WRITING BY
ROCKWELL AUTOMATION, INC.