Rockwell Automation 800MR-x_MS-x Pilot Light and Push-To-Test Units - Manual

BULLETIN 800MR MOUNTING INSTRUCTIONS
PILOT LIGHT AND PUSH-TO-TEST UNITS
BULB REPLACEMENT INSTRUCTIONS
1. Remove the lens assembly by grasping the lens cap
firmly with a pair of pliers and pull the assembly straight
out of the bushing.
2 . R e m o v e t h e b u l b b y p u s h i n g a n d t u r n i n g i t
c o n t e r c l o c k w i s e u s i n g t h e s m a l l e n d o f t h e b u l b
remover (Allen-Bradley Catalog Number 800T-N82),
and insert a new bulb using the same action in the
clockwise direction.
3. Snap the lens assembly back into the bushing.
For intermediate panel thickness, use the combination
specified for the smaller panel listed above. Panels thicker
than 1/4" must be counterbored 2" minimum diameter to 1/4".
Lens Assembly
Mounting Ring
Positioning Ring
Panel
Gaskets
Anti-Turn
Notch
Bushing
Operator Assembly
1/8" 1/8" Diameter
Drill (Alternate)
HORIZONTAL
SPACING
A
VERTICAL
SPACING
1/2"
B
7/8" Dia.
7/8" Dia.
Table 1 Number of Gaskets Required
Panel
.067" Gasket
(Black)
.034" Gasket
(Red)
1/16"
3/32"
1/8"
5/32"
3/16"
7/32"
1/4"
3
3
3
2
2
1
1 Plus
Plus
Plus
Plus
Plus
Plus
Plus 2
1
0
1
0
1
0
Type of Unit A Min. B Min.
1-1/4" 1-1/4"
All Bulletin 800MS, Bulletin
800MR Standard Legend Plate
1-1/2" 1-1/4"
Bulletin 800MR Large
Legend Plate
Step 1. Remove the mounting ring from the bushing.
Step 2. Select the proper combination of gaskets for the
panel thickness from Table 1 below, and install
them on the bushing.
Step 3. Insert the bushing through the panel from the rear.
The surface marked "top" should be in line with
the anti-turn notch in the panel.
Step 4. Install the legend plate (or positioning ring) on the
bushing, in line with the anti-turn notch in the
panel.
Step 5. Turn the mounting ring onto the bushing until it
stops, to compress the gaskets, and secure the
unit on the panel.
Note: To remove the entire unit from the panel, reverse
Steps 4 and 5.
PANEL MOUNTING PLAN
PREFERRED
B-vertical.ai
CONFIDENTIAL AND PROPRIETARY INFORMATION. THIS DOCUMENT
CONTAINS CONFIDENTIAL AND PROPRIETARY INFORMATION OF
ROCKWELL AUTOMATION, INC. AND MAY NOT BE USED, COPIED OR
DISCLOSED TO OTHERS, EXCEPT WITH THE AUTHORIZED WRITTEN
PERMISSION OF ROCKWELL AUTOMATION, INC.
BULLETIN 800MS AN 800MR
PILOT LIGHT AND PUSH-TO-TEST
INSTALLATION INSTRUCTION SHEET
40060-008
Sheet
Size Ver
Of 2 1
B 02
Dr. Date G. Ushakow 9-4-07