Rockwell Automation 509-TA_ Size 00 Enclosure Cover Replacement - Manual

1 1
ENCLOSURE COVER REPLACEMENT
INSTRUCTION SHEET
1 1017943
42052-141
OF
N/A
N/A
N/A
REVISION
AUTHORIZATION
DR.
CHKD.
APPD.
DATE
DATE
DATE
E - DOC
LOCATION: MILWAUKEE, WISCONSIN U.S.A.
B-vertical.ai
DWG.
SIZE
SHEET
B
1 2 3 4 5 6 7 8
A
B
C
D
E
G
H
REFERENCE
DIMENSIONS APPLY BEFORE
SURFACE TREATMENT
(DIMENSIONS IN INCHES)
TOLERANCES UNLESS
OTHERWISE SPECIFIED
.XX:
.XXX:
ANGLES:
41053
G. Ushakow 12-15-05
12-15-05
12-15-05
M. Jutz
C. Sauers
ATTENTION: To prevent electrical shock, disconnect from power source before installing or servicing.
Enclosure Cover Replacement
(Cat 509-TA_)
THIS DRAWING IS THE PROPERTY OF
ROCKWELL AUTOMATION, INC.
OR ITS SUBSIDIARIES AND MAY NOT BE COPIED,
USED OR DISCLOSED FOR ANY PURPOSE
EXCEPT AS AUTHORIZED IN WRITING BY
ROCKWELL AUTOMATION, INC.
42052-141-01 (1)
Printed in U.S.A.
PART
NO.
MATERIAL
CHG.
CHAR.
SIZE
-01 1
ONE SIDE PRINTED
8-1/2" W x 11" H BODY STOCK WHITE
BODY INK BLACK
The enclosure cover is provided with the reset button assembled for the Eutectic or SMP overload relays,
Bulletin 592-JOV16 or 592-A_ _ T for the E1-Plus overload relay, Bulletin 592-EE_T, the following
modifications must be made:
1. Remove the large nut that secures the reset assembly to the cover.
2. Remove the reset assembly.
3. Add the two plastic rings provided in the plastic bag then the blue reset label with the text toward the plastic
rings.
4. Install the reset assembly into the cover and torque the large nut to to 30 lb.-in.
5. Check for proper reset button travel by manually tripping the overload relay, then install the cover and push the
reset button. remove the cover and check that the overload relay is reset.