Rockwell Automation 42JT VisiSight Photoelectric Color Mark Sensors - Manual

Installation Instructions
42JT VisiSight™ Photoelectric Color Mark Sensors
IMPORTANT: SAVE THESE INSTRUCTIONS FOR FUTURE USE.
Default Settings:
Output Mode: Light Operate (Output ON when the color mark is
detected after being taught)
Output Type: PNP or NPN (Push-Pull)
Sensor User Interface
LED Status
The table below provides LED status in the RUN mode i.e., during
operation, the sensor is always in RUN mode, except when being
taught.
*LED status shown when the load is connected as PNP. The LED status reverses when the load is
connected as NPN. (e.g. LED is ON when the output is de-energized and OFF when is energized)
Mounting the Sensor
Securely mount the sensor on a firm, stable surface or support.
An application which is subject to excessive vibration or shifting
may cause intermittent operation. For installation convenience,
Rockwell Automation offers a wide range of mounting brackets
(see the Accessories section for more details).
Green
OFF Power is OFF
ON Power is ON
Flashing (1.5 Hz)
Output short circuit protection
active
Yellow*
OFF Output de-energized
ON Output energized
Yellow LED
Pushbutton
Green LED
General Specifications
 Replace with A2 for 2 m (6.6 ft) cable, F4 for 4-pin DC micro (M12) QD, or P4 on 4-pin DC pico
(M8) QD
 UL: -20…+50°C (-4…122°F)
42JT-F5LET1-
Environmental
Certifications cULus and CE Marked for all applicable directives
Operating Environment IP67, IP69K
Operating Temperature [C (F)] -20…+60° (-4…+140°) 
Storage Temperature [C (F)] -20…+80° (-4…+179°)
Optical
Light Source Visible white LED
Sensing Range [mm (in.)] 12 (0.47)
Tolerance [mm (in.)] +/- 2.5 (+/- 0.1)
Spot Size [mm (in.)] 1 x 4 (0.4 x 0.15)
Adjustments Pushbutton
Electrical
Voltage 10…30V DC
Current Consumption 25 mA max.
Sensor Protection Reverse polarity, short circuit protection
Outputs
Response Time 50 μs
Output Type PNP or NPN (Push-Pull)
Output Function Selectable light operate or dark operate
Output Current 100 mA max.
Output Leakage Current 10 μA max.
Mechanical
Housing Material ABS
Lens Material PMMA
Cover Material PMMA
Connection Types 2 m PUR cable, 4-pin DC micro (M12) QD on a 150 mm
PUR pigtail, 4-pin pico (M8) integral QD
Optional Accessories Mounting brackets, cordsets