Rockwell Automation 20P PowerFlex DC Drive - Frame A SCR Modules for Drives with Bus Bars - Manual

Installation Instructions
PowerFlex
®
DC Drive - Frame A SCR Modules
for Drives with Bus Bars
What This Kit Includes
•
SCR modules (3 for non-regenerative drives, 6 for regenerative drives)
•
Mounting screws and washers (6 for non-regenerative drives, 12 for
regenerative drives)
•
Gate leads (6 for non-regenerative drives, 12 for regenerative drives)
•
Thermal Grease
•
Static strap
Important: The SCR Modules supplied with this kit should only be used in
the following Frame A drives:
Tools That You Need
•
Phillips
®
screwdriver
•
Flathead screwdriver
•
Nut driver or wrench for hex stand-offs
•
Torque wrench
Phillips
®
is a registered trademark of Phillips Screw Company.
ATTENTION: Only qualified personnel familiar with DC
drives and associated machinery should plan or implement the
installation, start-up and subsequent maintenance of the system.
Failure to comply may result in personal injury and/or equipment
damage.
ATTENTION: To avoid an electric shock hazard, ensure that
all power to the drive has been removed before performing the
following.
ATTENTION: This drive contains ESD (Electrostatic
Discharge) sensitive parts and assemblies. Static control
precautions are required when installing, testing, servicing or
repairing this assembly. Component damage may result if ESD
control procedures are not followed. If you are not familiar with
static control procedures, reference A-B publication 8000-4.5.2,
“Guarding Against Electrostatic Damage” or any other
applicable ESD protection handbook.
230V AC Input 460V AC Input
Drive Current
Rating Code
DC Amps
AC Line
Amps
HP
Drive Current
Rating Code
DC Amps
AC Line
Amps
HP
073 73 60 20 073 73 59.6 40
093 93 76 25 086 86 70.3 50
110 110 90 30 100 100 81.7 60
129 129 105.4 75