Rockwell Automation 23P PowerFlex DC Stand-Alone Regulator (SAR) Discharge Resistor - Manual (Page 7)

Rockwell Automation Publication 23P-IN009A-EN-P - June 2011 7
Step 5: Remove the
Discharge Resistor
1. Remove the mounting screws (4).
2. Cut the wire at each soldered terminal directly behind the terminal. Leave as much
wire as possible for reassembly.
3. Dispose of the discharge resistor properly.
IMPORTANT Depending on sizing, the SAR may have three, or four, discharge
resistors. The example below shows four discharge resistors. Replace
only the damaged discharge resistors, as needed. It is not necessary to
replace all the discharge resistors at the same time.
Soldered Terminals (2).
Cut the wire directly
behind the terminal.
Mounting Screws (4)
Tightening torque:
2.5…4 N•m
(22…35.4 lb•in)
Discharge
Resistors.
Depending on
sizing, the SAR
may have 3 or 4
discharge
resistors.