Rockwell Automation 20P PowerFlex DC Drive - Frame D Overvoltage Clipping Board User Manual
Rockwell Automation Equipment
PowerFlex® DC Drive
Frame D Overvoltage Clipping Board
Installation Instructions
What This Kit Includes
•
Overvoltage clipping circuit board
•
Seven screws and washers
•
Static strap
Tools That You Need
•
Flathead screwdriver
•
Hexalobular screwdriver
What You Need to Do
The overvoltage clipping board is secured to the left side wall of the drive
frame. To install the overvoltage clipping board:
❐ Step 1: Remove power from the drive
❐ Step 2: Open the control panel
❐ Step 3: Remove the existing overvoltage clipping board
❐ Step 4: Install the new overvoltage clipping board
❐ Step 5: Close the control panel and document the change
ATTENTION: Only qualified personnel familiar with DC drives
and associated machinery should plan or implement the installation,
start-up and subsequent maintenance of the system. Failure to comply
may result in personal injury and/or equipment damage.
ATTENTION: To avoid an electric shock hazard, ensure that all
power to the drive has been removed before performing the following.
ATTENTION: This drive contains ESD (Electrostatic Discharge)
sensitive parts and assemblies. Static control precautions are required
when installing, testing, servicing or repairing this assembly.
Component damage may result if ESD control procedures are not
followed. If you are not familiar with static control procedures,
reference A-B publication 8000-4.5.2, “Guarding Against
Electrostatic Damage” or any other applicable ESD protection
handbook.