Rockwell Automation 20P PowerFlex DC Drive - Frame C Field SCR Module - Manual

Installation Instructions
PowerFlex
®
DC Drive - Frame C Field SCR
Module
What This Kit Includes
•
Field SCR module
•
Two screws and washers
•
Two gate leads
•
Thermal grease
•
Static strap
Important: It is highly recommended that the Field Snubber circuit board
and Field Dual Diode module be replaced when replacing the
Field SCR module. The Field Snubber circuit board and Field
Dual Diode module are sold as separate spare part kits.
Tools That You Need
•
Phillips
®
screwdriver
•
Flathead screwdriver
Phillips
®
is a registered trademark of Phillips Screw Company.
!
ATTENTION: Only qualified personnel familiar with DC
drives and associated machinery should plan or implement the
installation, start-up and subsequent maintenance of the system.
Failure to comply may result in personal injury and/or equipment
damage.
!
ATTENTION: To avoid an electric shock hazard, ensure that
all power to the drive has been removed before performing the
following.
!
ATTENTION: This drive contains ESD (Electrostatic
Discharge) sensitive parts and assemblies. Static control
precautions are required when installing, testing, servicing or
repairing this assembly. Component damage may result if ESD
control procedures are not followed. If you are not familiar with
static control procedures, reference A-B publication 8000-4.5.2,
“Guarding Against Electrostatic Damage” or any other
applicable ESD protection handbook.