Rockwell Automation 20P PowerFlex DC Drive - Frame C Armature Circuit Fuse Replacement User Manual
Powerflex
Installation Instructions
PowerFlex
®
DC Drive - Frame C Armature
Circuit Fuse Replacement
What This Kit Includes
•
One square body, high speed fuse (non-regenerative drives)
•
Two square body, high speed fuses (regenerative drives)
•
Static strap
Tools That You Need
•
Phillips
®
screwdrivers
•
Flathead screwdriver
•
17mm open ended wrench
Phillips
®
is a registered trademark of Phillips Screw Company.
What You Need to Do
To install the Armature circuit fuse(s):
❐ Step 1: Remove power from the drive
❐ Step 2: Remove the protective covers
❐ Step 3: Remove the existing fuse(s)
❐ Step 4: Install the new fuse(s)
❐ Step 5: Replace the protective covers
!
ATTENTION: Only qualified personnel familiar with DC
drives and associated machinery should plan or implement the
installation, start-up and subsequent maintenance of the system.
Failure to comply may result in personal injury and/or equipment
damage.
!
ATTENTION: To avoid an electric shock hazard, ensure that
all power to the drive has been removed before performing the
following.
!
ATTENTION: This drive contains ESD (Electrostatic
Discharge) sensitive parts and assemblies. Static control
precautions are required when installing, testing, servicing or
repairing this assembly. Component damage may result if ESD
control procedures are not followed. If you are not familiar with
static control procedures, reference A-B publication 8000-4.5.2,
“Guarding Against Electrostatic Damage” or any other
applicable ESD protection handbook.