Rockwell Automation 23P PowerFlex DC Stand-Alone Regulator (SAR) Fan Assembly User Manual
Installation instructions, What this kit includes, Tools that you need
Installation Instructions
23P-IN006A-EN-P
PowerFlex DC Stand-Alone Regulator (SAR)
Fan Assembly
What This Kit Includes
• Two fans wired together with one wiring harness and plug
• Four self-tapping sheet-metal screws
• Static strap
Tools That You Need
• Phillips
®
screwdriver
• Hexalobular screwdriver
Phillips
®
is a registered trademark of Phillips Screw Company.
What You Need to Do
The list below is an overview of the steps needed to remove and replace the fan
assembly. See each step for detailed procedures.
1.
2.
3.
4.
ATTENTION: Only qualified personnel familiar with DC drives and
associated machinery should plan or implement the installation,
start-up, and subsequent maintenance of the system. Failure to comply
may result in personal injury and/or equipment damage.
ATTENTION: To avoid an electric shock hazard, ensure that all power to
the SAR has been removed before performing the following.
ATTENTION: This SAR contains ESD (Electrostatic Discharge) sensitive
parts and assemblies. Static control precautions are required when
installing, testing, servicing, or repairing this assembly. Component
damage may result if ESD control procedures are not followed. If you are
not familiar with static control procedures, reference A-B publication
8000-4.5.2, “Guarding Against Electrostatic Damage,” or any other
applicable ESD protection handbook.