Rockwell Automation 23P PowerFlex DC Stand-Alone Regulator (SAR) Power Interface Circuit Board - Manual (Page 6)

6 Rockwell Automation Publication 23P-IN001A-EN-P - June 2011
2. Label and disconnect the plugs at connectors X3 and X4.
3. Label and disconnect the plugs at connectors XCD and XCD_IO.
4. Label and disconnect the ribbon cable at XPT1.
5. Label and disconnect the plugs at TH-CT and XF.
6. Label and disconnect the plugs at connectors at XP1 and XP2.
7. Label and disconnect the plug from connector XUVW.
8. Unplug the control power and relay terminal blocks.
9. Label and disconnect any external burden resistor circuit wires from the XCT
terminal.
10. Remove the mounting screws (2).
X3
X4
XCD
XCD_IO
XPT1
TH-CT
XF
XP1 and XP2
(respectively)
XUVW
Control Power and Relay
Terminal Block XCT Terminal
Mounting Screws (2)
Tightening torque:
1.0 N•m (8.9 lb•in)
XR