Rockwell Automation 20P PowerFlex DC Drive - Frame D Field Dual Diode Module User Manual
Rockwell Automation Equipment
PowerFlex® DC Drive
Frame D Field Dual Diode Module
Installation Instructions
What This Kit Includes
•
Field dual diode module
•
Screws and washers (2)
•
Thermal grease
•
Static strap
Important: It is highly recommended that the field circuit board and field SCR
module be replaced when replacing the field dual diode module.
The field circuit board and field SCR are sold as separate spare part
kits.
Tools That You Need
•
Phillips
®
screwdriver
•
Hexalobular screwdriver
Phillips
®
is a registered trademark of Phillips Screw Company.
ATTENTION: Only qualified personnel familiar with DC drives
and associated machinery should plan or implement the installation,
start-up and subsequent maintenance of the system. Failure to comply
may result in personal injury and/or equipment damage.
ATTENTION: To avoid an electric shock hazard, ensure that all
power to the drive has been removed before performing the following.
ATTENTION: This drive contains ESD (Electrostatic Discharge)
sensitive parts and assemblies. Static control precautions are required
when installing, testing, servicing or repairing this assembly.
Component damage may result if ESD control procedures are not
followed. If you are not familiar with static control procedures,
reference A-B publication 8000-4.5.2, “Guarding Against
Electrostatic Damage” or any other applicable ESD protection
handbook.